Course Overview This course is designed to support the FW update procedure for the Aruba line of access points. This is in response to the release of TI702-0146. Course Objective Provide the necessary knowledge for the learner to be able to complete the firmware update of the access point.. Course Contents Backup AP Perform FW […]
Course Overview This training course provides instruction on how to perform the stand calibration on the KDR Flex OTC. Course Objective Provide the necessary knowledge for the learner to be able to complete the calibration at install or PM. Course Contents OTC Alpha Angle Servo Assistance Sensors OTC Beta Angle OTC Longitudinal Axis OTC Transversal […]
Course Overview The following training provides instruction on how to configure the Ultra application for DICOM Modality Worklist (MWL) and PACS (DICOM STORE). Course Objective This mini training course will review how to configure the Ultra acquisition software for DICOM Modality Worklist (RIS) and for sending to PACS (DICOM Store). This is not a complete […]
Course Overview The following training provides instruction on how to perform an AeroDR panel calibration for the Ultra acquisition software using narrated multimedia video instruction. Course Objective Provide the necessary knowledge for the learner to be able to perform an AeroDR panel calibration for the Ultra acquisition software. This training course covers Ultra AeroDR panel […]
Course Overview This training course provides instruction on how to perform the installation of the new secondary monitor that will be replacing the tablet PC on the KDR AU. Course Objective Provide the necessary knowledge for the learner to be able to setup the secondary monitor. Course Contents Materials Download Parts/Software List Stand Hardware Installation […]
Course Overview This updated and expanded training course provides instruction on how to install, configure and service the Ultra acquisition station together with AeroDR detectors in a retrofit configuration. The course uses multimedia content including narrated video instruction, graphics and written instruction. Course Objective Provide the necessary knowledge for the learner to be able to […]
Course Overview This training course provides instruction on how to replace the gas shock assembly inside the stand of the KDR AU and Primary u-arm systems. Course Objective Provide the necessary knowledge for the learner to be able to remove and insert a new shock assembly. This is usually needed when the stand makes a […]
Course Overview This training course provides instruction on how to perform the software switch limits calibration on the KDR-AU and Primary u-arm stands. Course Objective Provide the necessary knowledge for the learner to be able to set the software limits for motors M1-M5. Course Contents Documentation Locations Video Procedure Course Prerequisite The learner must […]
Course Overview This training course provides instruction on how to perform software upgrades to the Konica Minolta Ultra acquisition station using a combination of video demonstrations and written instruction. Course Objective Provide the necessary knowledge for the learner to be able to perform software upgrades to the Ultra acquisition station while following the version-specific upgrade […]
Course Overview This course provides information about setting up and calibrating the IP camera that comes with the Ralco 3 button collimators. Course Prerequisite The learner should already be trained on the KDR AU/Primary/Straight Arm. Authors GP Delvecchio Duration Approx. 30 Minutes
Global