With the introduction of stand firmware version 37 and higher, the calibration that is performed for position settings of motors M1-M5 has changed. This training will outline the new procedure.
Course Objective
Provide the necessary knowledge for the learner to be able to perform the calibration procedure.
- Setting the degree positions for M1 and M5
- Setting the start and end positions for motors M2 through M4
- Setting Upper Limit
- Checking proximity sensors
- Other checks
Course Contents
- Video instruction demonstrating procedure
Course Prerequisite
- The learner must have attended a training course conducted by Konica Minolta that included the KDR Advanced/Primary U-Arm System.
- Only Purchase Order payments will be accepted for this training course.
- Once purchase order is uploaded and received, your purchase is in the validation state during which we will check your training records.
- If approved, we will release the training course contents to you.
- Billing will only occur if the course is approved and its contents are released to you.
Typical Time Needed to Complete Course
Approximately 60 minutes.
Author
GP DelVecchio
Global
