Global
Expired [UE05J34] Floor Mount and Manual OTC Systems – Feb 21 – Feb 23
Event Phone: 919-792-6420
-
Day 1 - Day 3
February 21, 2023 - February 23, 2023
9:00 am - 4:00 pm
Course Objective:
This seminar will provide each attendee with the skills to efficiently service and install the following components of Konica Minolta DR systems:
-Sedecal Floor Mount System
-Sedecal Generators
-AeroDR Detectors
-Siemens 3D Tube Hanger
-Sedecal NET Table
-Ultra Software
Note: Last day end time: 4:00PM. See details in Course Specifications below.
Additional Information:
COVID-19 Protocols
- Those exposed to the virus are no longer required to quarantine. However, it is recommended to wear a high-quality mask for 10 days and get tested again on day 5.
- If you test positive for COVID-19, you should stay home for at least 5 days.
- Unvaccinated people now have the same guidance as vaccinated people.
- Students attending training are no longer required to provide proof of vaccination.
Prerequisites
- Minimum two (2) years X-ray service experience
- Windows operating system experience
- Ability to read and comprehend schematics drawings
- Minimum two (2) years electronics trouble-shooting experience
Target Audience
Service Engineers
Course Specifications
Course Length: 3 days
Hours: Tue – Thurs: 9:00AM to 4:00PM
Lunch will be at 12:00
Course Topics
Topics may vary depending upon prior class knowledge and experience
Day 1:
Overview
- Mission statement
- Advantages of Digital Radiography
- Course expectations
- Safety overview
- Introduction to manuals
Overview of the Sedecal Floor Mount System
- Site planning guides
- Minimum room requirements
- Mandatory site preparation
- Sub-assemblies
- Theory of operation
- Interfaces to other elements
- Introduction to the major system components
- Review diagram of interconnect cables
- Floor Mount Installation
Day 2:
Sedecal Generator
- Installation process
- Configuration of tube and stator
- Workstation setup
- Calibration
- AEC
- Circuit analysis
- Troubleshooting
Overview of the DR Panels
- Review the multiple components
- Basic operation of a Flat Panel
- Optimal performance specifications
- Sub-assembly
- Theory of operation
Lab
- Identify replaceable components
- Connect & wire Imaging Detector
- Configure & calibrate the stand
- Configure & calibrate the generator
Day 3:
Ultra Software
- Application of Tech Service
- Log-in requirements
- Operation of the Ultra application
- Image acquisition
- Scheduling & performing studies
- Navigating images
- Send & print image functions
- DICOM Configuration
- Service level philosophy
Siemens Manual OTC System:
- Introduction to Siemens Manual OTC System
- Siemens OTC Installation process
- Site planning
- Calibration
- Review of generator, positioners and panels
- Troubleshooting
- Feedback
Venue: Konica Minolta Healthcare Americas, Inc.
Address: