Sold Out[UE05J44] KDR™ AU and Manual OTC Systems – Feb 15 – Feb 18

Event Phone: 919-792-6420

We're sorry, but all tickets sales have ended because the event is expired.
  • Day 1 - Day 3
    February 15, 2022 - February 17, 2022
    9:00 am - 4:00 pm
  • Day 4
    February 18, 2022
    9:00 am - 11:00 am

Course Objective:

This seminar will provide each attendee with the skills to efficiently service and install the following components of Konica Minolta DR systems:

-KDR™ AU and Primary System
-Sedecal Generators
-AeroDR Detectors
-Siemens 3D Tube Hanger
-Sedecal NET Table
-Ultra Software

Note: Last day end time: 11:00AM.  See details in Course Specifications below.

Additional Information:

COVID-19 Protocols

  1. Konica Minolta Healthcare Americas or KMHA mandates that all attendees be vaccinated in order to enter KMHA facilities.  Proof of vaccination will be required at time of registration. Covid-19 antibodies are not an alternative to vaccination.
  2. Please do not attend training if you have a fever or symptoms of illness like a cough.
  3. Regardless of vaccination status, all learners will be required to wear a face-covering while on Konica Minolta grounds.  This includes the classroom area unless 100% of the attendees/instructor agree, or are comfortable with an unmasked class.  Masks must always be worn in KMHA common areas.
  4. Failure to comply with these rules will result in the individual being removed from the course and sent home.  The tuition will not be refunded.

Prerequisites

  • Minimum two (2) years X-ray service experience
  • Windows operating system experience
  • Ability to read and comprehend schematics drawings
  • Minimum two (2) years electronics trouble-shooting experience

Target Audience

Service Engineers

Course Specifications

Course Length: 4 days
Hours: Tue – Thurs: 9:00AM to 4:00PM
Friday: 9:00AM – 11:00AM
Lunch will be at 12:00

Course Topics


Topics may vary depending upon prior class knowledge and experience

Day 1: 

Overview

  • Mission statement
  • Advantages of Digital Radiography
  • Course expectations
  • Safety overview
  • Introduction to  manuals

Overview of the KDR™ AU

  • Design and similarities
  • Site planning guides
  • Minimum room requirements
  • Mandatory site preparation
  • Sub-assemblies
  • Theory of operation
  • Interfaces to other elements
  • Introduction to the major system components
  • Review diagram of interconnect cables

Day 2: Sedecal Generator

  • Installation process
  • Configuration of tube and stator
  • Workstation setup
  • Calibration
  • AEC
  • Circuit analysis
  • Troubleshooting

Day 3: Overview of the DR Panels

  • Review the multiple components
  • Basic operation of a Flat Panel
  • Optimal performance specifications
  • Sub-assembly
  • Theory of operation

Lab

  • Identify replaceable components
  • Connect & wire Imaging Detector
  • Configure & calibrate the stand
  • Configure & calibrate the generator

 Ultra Software

  • Application of Tech Service
  • Log-in requirements
  • Operation of the  Ultra application
  • Image acquisition
  • Scheduling & performing studies
  • Navigating images
  • Send & print image functions
  • Dicom Configuration
  • Service level philosophy

Day 4 (half day):

  • OTC Installation process
  • Site planning
  • Calibration
  • Review of generator, positioners and panels
  • Troubleshooting
  • Feedback

 

Venue:  

Address:
2217 US 70 Hwy E, Garner, 27529, United States