Course Overview

The following training provides instruction on how to perform installation and service for the CS-7 One Shot Stitching system using narrated multimedia video instruction and written instruction.

Course Objective

Provide the necessary knowledge for the learner to be able to perform installation and service for the CS-7 One Shot Stitching system.

This self-paced training course is meant as an aid to the documented Installation Procedure for the One Shot Stitching Image Device located in the CS-7 Installation Service Manual and is not a substitute for this procedure.  Read through and follow the installation instructions in the service manual.

Course Contents

Course topics include the following:

• What is CS-7 One Shot Stitching
• How to configure CS-7 One Shot Stitching
• How to calibrate CS-7 One Shot Stitching
• How to make a test exposure and interpret the user interface icons
• Possible errors

Rev 2 of this training course includes new information received from Konica Minolta Japan for the One Shot Stitch System
Chapters designated with a * are either new or have been updated.  If you have previously taken this course, thoroughly review these sections.

What is new in Rev 2:

• Introduction of One Shot Markers
• New CS-7 setting to set the type of Panel Holder used in the One Shot Stitch Stand
• Troubleshooting possible image artifacts
• Initial Exam Tag configuration has been added

Course Prerequisite

Attendance to a Konica Minolta instructed CS-7 AeroDR Service Training class.

Typical Time Needed to Complete Course

Approximately 85 minutes.

Author

Gregory Guido